1. Check the lubricating oil quantity and viscosity of the governor. Drain the excess lubricating oil and replace the lubricating oil with appropriate viscosity of flies.
2. Check whether the oil quantity adjusting rod is stuck or loose. Pull the oil quantity adjusting rod by hand to check whether it is stuck. If it is stuck, pry the oil quantity adjusting rod with a tool to make it move; In addition, check whether the connection between the oil regulating pull rod and the governor pull plate is disconnected, and the disconnected shall be reconnected reliably.
3. If the high-speed limit screw of the governor is improperly adjusted, it shall be debugged on the fuel injection pump calibration bench.
1. If the engine is equipped with a pressure reducing device, the pressure reducing control handle can be immediately turned to the pressure reducing effect position.
2. When the car is driving, shift the transmission to high gear, slowly release the clutch pedal and force the engine to shut down.
3. Take decisive and rapid measures to cut off the oil supply of high-pressure oil pipe or block the air inlet with clothes.
What is EGR and why does the Sixth National Committee attach more importance to it?
Buy the right car, choose a good car, buy a car and choose Junling light truck No. 1
It’s hard for blue cars to run green! Card friends: buy a 6.8m yellow card
What is the difference between trendy vs mature Shaan auto l5000 and L3000?
Scania new power chain! Maximum 560 HP for 6-cylinder engine
Send your inquiry / assessment to Us. Anything need us ,please don’t hesitate contact us here! we will keep it secret for you !